Difficulty

Moderate

Steps

7

Time Required

                          30 minutes - 1 hour

Sections

2

  • Battery
  • 4 steps
  • Daughterboard
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHTC Desire 826

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Find a seam in the back of the device.
  • Insert the plastic spudger into the seam and pry off the back panel.
  • There will be glue, so keep prying until it comes off or you may need to heat up the edges of the device to loosen the adhesive with the iOpener.

Find a seam in the back of the device.

Insert the plastic spudger into the seam and pry off the back panel.

There will be glue, so keep prying until it comes off or you may need to heat up the edges of the device to loosen the adhesive with the iOpener.

1024

Step 2

  • Remove the 4.0 mm screw above the battery with a T5 Torx screwdriver.
  • Remove the metal bracket with the tweezers.

Remove the 4.0 mm screw above the battery with a T5 Torx screwdriver.

Remove the metal bracket with the tweezers.

Step 3

  • Disconnect the battery cable from the motherboard with the tweezers.

Disconnect the battery cable from the motherboard with the tweezers.

Step 4

  • Lift the battery with a plastic spudger and remove it from the device.

Lift the battery with a plastic spudger and remove it from the device.

Step 5

              Daughterboard
  • Use a T5 Torx screwdriver to remove the two 4.0 mm screws in the bottom corners of the device.

Use a T5 Torx screwdriver to remove the two 4.0 mm screws in the bottom corners of the device.

Step 6

  • Use a T5 Torx screwdriver to remove one screw connected to the daughterboard.

Use a T5 Torx screwdriver to remove one screw connected to the daughterboard.

Step 7

  • Remove the interconnect ribbon cable by flipping up the black tab of the ZIF connector and pulling out the cable with your fingers.
  • Remove the daughterboard.

Remove the interconnect ribbon cable by flipping up the black tab of the ZIF connector and pulling out the cable with your fingers.

Remove the daughterboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Porntep Chaisang

Member since: 09/17/2020

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       The Citadel Military College of South Carolina, Team S3-G18, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S3-G18, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S3G18                     


                                            3 Members                     


                                            6 Guides authored