Difficulty

Moderate

Steps

7

Time Required

                          10 minutes

Sections

2

  • Battery
  • 4 steps
  • Back Camera
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHTC Desire 826

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Find a seam in the back of the device.
  • Insert the plastic spudger into the seam and pry off the back panel.
  • There will be glue, so keep prying until it comes off or you may need to heat up the edges of the device to loosen the adhesive with the iOpener.

Find a seam in the back of the device.

Insert the plastic spudger into the seam and pry off the back panel.

There will be glue, so keep prying until it comes off or you may need to heat up the edges of the device to loosen the adhesive with the iOpener.

1024

Step 2

  • Remove the 4.0 mm screw above the battery with a T5 Torx screwdriver.
  • Remove the metal bracket with the tweezers.

Remove the 4.0 mm screw above the battery with a T5 Torx screwdriver.

Remove the metal bracket with the tweezers.

Step 3

  • Disconnect the battery cable from the motherboard with the tweezers.

Disconnect the battery cable from the motherboard with the tweezers.

Step 4

  • Lift the battery with a plastic spudger and remove it from the device.

Lift the battery with a plastic spudger and remove it from the device.

Step 5

              Back Camera
  • Use a T5 Torx screwdriver to remove the three 4.0 mm screws.

Use a T5 Torx screwdriver to remove the three 4.0 mm screws.

Step 6

  • Use the spudger to lift the black plastic covering.

Use the spudger to lift the black plastic covering.

Step 7

  • Use the spudger to lift the green board. The back camera is attached on the side as shown.
  • Use the tweezers to disconnect and remove the camera.

Use the spudger to lift the green board. The back camera is attached on the side as shown.

Use the tweezers to disconnect and remove the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Jordan Warnix

Member since: 09/04/2019

285 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of Alabama, Team S1-G2, Bedsole Fall 2019                        

                                                  Member of University of Alabama, Team S1-G2, Bedsole Fall 2019 



                    UA-BEDSOLE-F19S1G2                     


                                            4 Members                     


                                            10 Guides authored