Htc Desire 610 Daughterboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Daughterboard
12 steps

Flags

BackHTC Desire 610
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Daughterboard

Open the SD card slot.

Open the SD card slot.

1024

Step 2

Using plastic opening tool, take off the back cover of the phone.

Using plastic opening tool, take off the back cover of the phone.

Step 3

Using Phillips #000 Screwdriver, remove the two 2.5mm phillips head screws.

Using Phillips #000 Screwdriver, remove the two 2.5mm phillips head screws.

Step 4

Using Torx T5 Screwdriver, remove the four 5mm silver torx head screws.

Using Torx T5 Screwdriver, remove the four 5mm silver torx head screws.

Step 5

Using Torx T5 Screwdriver, remove the four 4mm black torx screws

Using Torx T5 Screwdriver, remove the four 4mm black torx screws

Step 6

Using plastic opening tool, remove the black plastic circuit cover.

Using plastic opening tool, remove the black plastic circuit cover.

Step 7

Using Torx T5 Screwdriver, remove the 4mm black torx screw.

Using Torx T5 Screwdriver, remove the 4mm black torx screw.

Step 8

Using Tweezers, disconnect antenna wire.

Using Tweezers, disconnect antenna wire.

Step 9

Using Tweezers, remove loud speaker that is being held by small adhesive.
When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone.

Using Tweezers, remove loud speaker that is being held by small adhesive.

When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone.

Step 10

Using Tweezers, peel back gray adhesive.

Using Tweezers, peel back gray adhesive.

Step 11

Using Tweezers, flip the white strip upward so it sits 90°.

Using Tweezers, flip the white strip upward so it sits 90°.

Step 12

Using plastic opening tool, pry up green plate and pull outward.
Daughterboard is off. Get new daughterboard and reverse steps.

Using plastic opening tool, pry up green plate and pull outward.

Daughterboard is off. Get new daughterboard and reverse steps.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors

                    Austin Phelps

Member since: 01/31/2016

194 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of Alabama, Team 1-2, Sydow campbell Spring 2016                        

                                                  Member of University of Alabama, Team 1-2, Sydow campbell Spring 2016 



                    UA-SYDOW CAMPBELL-S16S1G2                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team