Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
2
- Back Panel
- 3 steps
- Speakers
- 3 steps
Flags
0
BackHP 8 1401
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.
Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.
1024
Step 2
- Insert the tip of a plastic opening tool in the seam between the front and back panels.
Insert the tip of a plastic opening tool in the seam between the front and back panels.
Step 3
- Slide the plastic opening tool around all edges of the device until the back panel detaches.
- Lift off the back panel.
Slide the plastic opening tool around all edges of the device until the back panel detaches.
Lift off the back panel.
Step 4
Speakers
- Using tweezers or your fingers, disconnect the two speaker cables by pulling them free of the socket connectors.
Using tweezers or your fingers, disconnect the two speaker cables by pulling them free of the socket connectors.
Step 5
- Use a spudger to pry the speakers up and out of the case.
Use a spudger to pry the speakers up and out of the case.
Step 6
- After removing the speakers they should look like this.
After removing the speakers they should look like this.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Katie Presz
Member since: 01/16/2019
641 Reputation
6 Guides authored
Badges:
6
+3 more badges
Team
University of Alabama, Team S1-G1, Bedsole Spring 2019
Member of University of Alabama, Team S1-G1, Bedsole Spring 2019
UA-BEDSOLE-S19S1G1
4 Members
6 Guides authored
