Hp Windows Mixed Reality Controllers Tpc Q044 Small Circuit Board Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          35 minutes            

Sections

3

• Batteries
• 1 step
• Shell
• 3 steps
• Small Circuit Board
• 2 steps

Flags

0

• BackHP Controllers TPC-Q044

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

You will need to have a new circuit board to replace the old one with.

Be careful around the edges of the circuit board as they can be sharp and you could possibly cut yourself.

What you need

Step 1

              Batteries               

• Slide the rear compartment cover in the direction of the arrow.
• If replacing batteries, ensure the (+) and (-) on the battery match the (+) and (-) labeled in the battery compartment.

Slide the rear compartment cover in the direction of the arrow.

If replacing batteries, ensure the (+) and (-) on the battery match the (+) and (-) labeled in the battery compartment.

1024

Step 2

              Shell               

• Remove the four 4mm screws using a Phillips #00 screwdriver.

Remove the four 4mm screws using a Phillips #00 screwdriver.

Step 3

• Grip the main body and pull the joystick outwards until the entire front panel pops off.
• Remove the 6mm screw in the corner of the joystick well using a Phillips #00 screwdriver.

Grip the main body and pull the joystick outwards until the entire front panel pops off.

Remove the 6mm screw in the corner of the joystick well using a Phillips #00 screwdriver.

Step 4

• Use a spudger to pry apart the two halves of the assembly.
• Work slowly, prying a small section at a time until the halves are completely separated.

Use a spudger to pry apart the two halves of the assembly.

Work slowly, prying a small section at a time until the halves are completely separated.

Step 5

              Small Circuit Board               

• Using a Phillips #00 screwdriver, remove the four 4mm screws located on the joystick circuit board underneath the top half of the controller.

Using a Phillips #00 screwdriver, remove the four 4mm screws located on the joystick circuit board underneath the top half of the controller.

Step 6

• Remove the orange flat cable by pulling the orange tab parallel to the circuit board.
• Release the blue flat cable by lifting up the white latch with a spudger.

Remove the orange flat cable by pulling the orange tab parallel to the circuit board.

Release the blue flat cable by lifting up the white latch with a spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Clement Cheung                     

Member since: 01/24/2019

607 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Cal Poly, Team S18-G5, White Winter 2019                        

                                                  Member of Cal Poly, Team S18-G5, White Winter 2019 



                    CPSU-WHITE-W19S18G5                     


                                            2 Members                     


                                            12 Guides authored                     

Emerald Wolf - Apr 2, 2019

Reply

Where would I be able to buy a replacement small board?