Difficulty
Easy
Steps
7
Time Required
7 minutes
Sections
1
- Display Panel Cable
- 7 steps
Flags
0
BackHP Stream 8
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Display Panel Cable
- Use your nail to pry up the back cover of the device.
Use your nail to pry up the back cover of the device.
1024
Step 2
- Fully remove the back cover.
Fully remove the back cover.
Step 3
- Remove the 10 3mm screws using the Phillips #00 screwdriver.
Remove the 10 3mm screws using the Phillips #00 screwdriver.
Step 4
- Pry up the inside cover the same way as you did with the back cover.
Pry up the inside cover the same way as you did with the back cover.
Step 5
- Remove the USB flex ribbon cable from the connection point.
Remove the USB flex ribbon cable from the connection point.
Step 6
- Carefully disconnect the display panel cable from the system board.
Carefully disconnect the display panel cable from the system board.
Step 7
- Remove the display panel cable.
Remove the display panel cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Ashley Eimers
Member since: 04/01/2019
265 Reputation
2 Guides authored
Badges:
3
Team
IUPUI, Team S1-G3, Harley Spring 2019
Member of IUPUI, Team S1-G3, Harley Spring 2019
IUPUI-HARLEY-S19S1G3
3 Members
2 Guides authored
