Difficulty
Moderate
Steps
4
Time Required
5 - 10 minutes
Sections
2
- Keyboard
- 2 steps
- Wireless Card
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackHP Stream 13-c002dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Keyboard
- Begin by placing your laptop on a clean surface such as a table and away from any liquids which may spill and damage components.
- Flip the laptop over so the bottom is facing up and use your Phillips #0 screwdriver to remove the 11 visible 5mm screws on the back.
- There are some screws underneath the rubber feet. Remove them to gain access
- Unscrew the two remaining 2.5mm screws. Keep these screws separate from the first eleven 5mm screws.
Begin by placing your laptop on a clean surface such as a table and away from any liquids which may spill and damage components.
Flip the laptop over so the bottom is facing up and use your Phillips #0 screwdriver to remove the 11 visible 5mm screws on the back.
There are some screws underneath the rubber feet. Remove them to gain access
Unscrew the two remaining 2.5mm screws. Keep these screws separate from the first eleven 5mm screws.
1024
Step 2
- Flip the laptop back over onto its normal side up and raise the screen. Using the metal spudger, separate the keyboard surface from the bottom of the laptop.
- While lifting the keyboard surface from the bottom, you will notice three cables still attaching them together. Gently unplug each of these cables from the motherboard.
- With the screen and keyboard parts of the laptop removed, you have access to the laptop’s internal components.
Flip the laptop back over onto its normal side up and raise the screen. Using the metal spudger, separate the keyboard surface from the bottom of the laptop.
While lifting the keyboard surface from the bottom, you will notice three cables still attaching them together. Gently unplug each of these cables from the motherboard.
With the screen and keyboard parts of the laptop removed, you have access to the laptop’s internal components.
Step 3
Wireless Card
- Inside the laptop you will notice the wireless card located in the upper middle. This will be what you are replacing.
- Attached to the Wi-Fi card is a black wire that must be removed. Using your hand, lift gently on the wire as close as you can to where it connects to the Wi-Fi card.
- Once the wire is removed, set it aside so it does not get damaged.
Inside the laptop you will notice the wireless card located in the upper middle. This will be what you are replacing.
Attached to the Wi-Fi card is a black wire that must be removed. Using your hand, lift gently on the wire as close as you can to where it connects to the Wi-Fi card.
Once the wire is removed, set it aside so it does not get damaged.
Step 4
- Remove the screw holding the wireless card in place.
- With the screw removed, gently pull back the Wi-Fi card and then lift it out of the laptop. You are now ready to insert the new wireless card.
Remove the screw holding the wireless card in place.
With the screw removed, gently pull back the Wi-Fi card and then lift it out of the laptop. You are now ready to insert the new wireless card.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 8 other contributors
Hailee McCraw
Member since: 01/23/2018
221 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
Western Carolina University, Team S1-G1, Virtue Spring 2018
Member of Western Carolina University, Team S1-G1, Virtue Spring 2018
WCU-VIRTUE-S18S1G1
4 Members
11 Guides authored
