Hp Stream 11 Y010Nr Keyboard Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 minutes            

Sections

1

• Keyboard
• 5 steps

Flags

0

• BackHP Stream 11-y010nr

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Prior to beginning, ensure the laptop is completely powered off such that it will not interfere with the steps in this guide.

What you need

Step 1

              Keyboard               

• Gently peel back the two rubber strips that cover the screws on backside of the computer with the needle nose tweezers.
• Ensure the laptop is turned off.

Gently peel back the two rubber strips that cover the screws on backside of the computer with the needle nose tweezers.

Ensure the laptop is turned off.

1024

Step 2

• Unscrew the seven 0.4mm screws on the backside of the laptop with the Phillips #0 Screwdriver.

Unscrew the seven 0.4mm screws on the backside of the laptop with the Phillips #0 Screwdriver.

Step 3

• Take the opening picks and push them into the seam between the keyboard and the laptop casing.
• Go all the way around the laptop.

Take the opening picks and push them into the seam between the keyboard and the laptop casing.

Go all the way around the laptop.

Step 4

• Once the cover is loose enough, lift the keyboard up to expose the wiring beneath.
• Be careful not to pull too hard or fast as there are ribbon cables attached to the keyboard and trackpad.

Once the cover is loose enough, lift the keyboard up to expose the wiring beneath.

Be careful not to pull too hard or fast as there are ribbon cables attached to the keyboard and trackpad.

Step 5

• Disconnect the three cables by lifting up on the locking tab of the ZIF connector and pulling the cables out with the needle nose tweezers.
• Remove the keyboard.

Disconnect the three cables by lifting up on the locking tab of the ZIF connector and pulling the cables out with the needle nose tweezers.

Remove the keyboard.

To reassemble your device, follow these instructions.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Adam Sitzmann                     

Member since: 01/26/2020

914 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S5-G6, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S5-G6, Watkins Spring 2020 



                    ERAU-WATKINS-S20S5G6                     


                                            4 Members                     


                                            6 Guides authored