Difficulty

Moderate

Steps

6

Time Required

                          25 minutes

Sections

1

  • Battery
  • 6 steps

Flags

0

  • BackHP Stream 11-r014wm

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.
  • Use a plastic spudger to remove four rubber feet.
  • To remove the feet you must break the glue seal holding them down.

Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.

Use a plastic spudger to remove four rubber feet.

To remove the feet you must break the glue seal holding them down.

1024

Step 2

  • Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.

Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.

Step 3

  • Turn the computer over and open it.
  • Use a plastic spudger to pry the keyboard bezel away from the base. Pry around the edge, being careful not to jam the spudger too far underneath the bezel (potentially damaging internal components).
  • The bezel is tightest near the hinge.
  • Once the bezel is free, do not lift it away from the base.

Turn the computer over and open it.

Use a plastic spudger to pry the keyboard bezel away from the base. Pry around the edge, being careful not to jam the spudger too far underneath the bezel (potentially damaging internal components).

The bezel is tightest near the hinge.

Once the bezel is free, do not lift it away from the base.

Step 4

  • Identify two ribbon connectors and the ZIF cable underneath the keyboard.
  • Use tweezers to disconnect both ribbon cables and the ZIF connector.

Identify two ribbon connectors and the ZIF cable underneath the keyboard.

Use tweezers to disconnect both ribbon cables and the ZIF connector.

Step 5

  • Use a Phillips #00 screwdriver to remove six 5 millimeter screws from the battery.

Use a Phillips #00 screwdriver to remove six 5 millimeter screws from the battery.

Step 6

  • Use a plastic spudger to remove the two power connectors.
  • Lift the battery out.

Use a plastic spudger to remove the two power connectors.

Lift the battery out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Anthony R Cardinali

Member since: 04/05/2018

988 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Linn Benton Community College, Team S1-G3, Johnson Spring 2018                        

                                                  Member of Linn Benton Community College, Team S1-G3, Johnson Spring 2018 



                    LBCC-JOHNSON-S18S1G3                     


                                            4 Members                     


                                            5 Guides authored