Hp Stream 11 D020Nr Lower Case Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Lower Case
4 steps

Flags

BackHP Stream 11-d020nr
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Lower Case

Before disassembly, unplug and power off the Stream 11.
Pry off the two elliptical rubber inserts (one in each corner).
Pry off the two circular rubber inserts below the removed elliptical inserts (one in each corner).

Before disassembly, unplug and power off the Stream 11.

Pry off the two elliptical rubber inserts (one in each corner).

Pry off the two circular rubber inserts below the removed elliptical inserts (one in each corner).

1024

Step 2

Remove the eleven 5.6 mm Phillips #00 screws.

Remove the eleven 5.6 mm Phillips #00 screws.

Step 3

Turn the computer upright and lift the screen.
Carefully use a spudger to pry the plastic keyboard cover from the base.
When using the metal spudger, be careful not to press into the components underneath the keyboard cover. If possible, use a standard spudger or plastic opening tool to remove the keyboard cover.
Work the spudger around the cover to release the clips attaching the cover to the base.
Be patient when removing the cover, as there are many clips and it may take some time.

Turn the computer upright and lift the screen.

Carefully use a spudger to pry the plastic keyboard cover from the base.

When using the metal spudger, be careful not to press into the components underneath the keyboard cover. If possible, use a standard spudger or plastic opening tool to remove the keyboard cover.

Work the spudger around the cover to release the clips attaching the cover to the base.

Be patient when removing the cover, as there are many clips and it may take some time.

Step 4

Disconnect the cable connecting the ClickPad to the base.
Remove the plastic keyboard cover.
The cover is attached to the ClickPad by a cable. Be careful not to lift the cover too far so you do not damage this cable.

Disconnect the cable connecting the ClickPad to the base.

Remove the plastic keyboard cover.

The cover is attached to the ClickPad by a cable. Be careful not to lift the cover too far so you do not damage this cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 6 other contributors

                    Ian Somerville

Member since: 03/10/2016

122 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 3-5, Wollert Spring 2016                        

                                                  Member of USF Tampa, Team 3-5, Wollert Spring 2016 



                    USFT-WOLLERT-S16S3G5                     


                                            5 Members                     


                                            19 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team