Difficulty

Moderate

Steps

5

Time Required

                          5 - 10 minutes

Sections

1

  • Screen
  • 5 steps

Flags

0

  • BackHP Star Wars Special Edition 15-an051dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

  • If your device screen on the HP Star Wars Special Edition 15-an051dx is not displaying any output follow this guide to help facilitate the process of replacing your screen.After powering your device and there is no output on your screen make the necessary changes with the steps shown below.Ensure you have powered off your device completely and disconnected any external power source.Gather the necessary tools shown in the tools section and begin your disassembling process.

What you need

Step 1

              Screen
  • Make sure the laptop is fully powered down and unplugged before you start.
  • Remove the two circular plastic screw covers, then remove the two 4.5 mm screws in the using a Phillips #1 screwdriver.

Make sure the laptop is fully powered down and unplugged before you start.

Remove the two circular plastic screw covers, then remove the two 4.5 mm screws in the using a Phillips #1 screwdriver.

1024

Step 2

  • Insert a spudger in between the bezel and display, at the top.
  • Move the tool around all sides of the bezel.
  • With your finger, lift the inside part of the bezel.
  • Pull the bezel back; it will pop-off.

Insert a spudger in between the bezel and display, at the top.

Move the tool around all sides of the bezel.

With your finger, lift the inside part of the bezel.

Pull the bezel back; it will pop-off.

Step 3

  • Remove the four 2.75 mm screws using a Phillips #1 screwdriver
  • Lift the screen using a spudger.

Remove the four 2.75 mm screws using a Phillips #1 screwdriver

Lift the screen using a spudger.

Step 4

  • Lifting the tape on the back of the screen and peel it off.
  • Remove the connection.

Lifting the tape on the back of the screen and peel it off.

Remove the connection.

Step 5

  • Connect the new screen using the 30 pin cable.
  • Put the screen in place.

Connect the new screen using the 30 pin cable.

Put the screen in place.

Enjoy your new screen!

Take your e-waste to an R2 or e-Stewards certified recycler.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Fernando Mendez

Member since: 08/25/2022

583 Reputation

                                      5 Guides authored                  



                       Badges:
                       7





                                                        +4 more badges

Team

                       Gateway, Team 1-2, Pee Fall 2022                        

                                                  Member of Gateway, Team 1-2, Pee Fall 2022 



                    GCC-PEE-F22S1G2                     


                                            4 Members                     


                                            5 Guides authored