Hp Star Wars Special Edition 15 An051Dx Battery Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          15 - 30 minutes

Sections

Battery
3 steps

Flags

BackHP Star Wars Special Edition 15-an051dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

If the device is overheating, not charging, or experiencing short run times and shutdowns this may mean there is a faulty battery. You will need to open your device and replace the battery.Before you begin, make sure to take the time to inspect the potential symptoms that indicate the device issue is relating to the battery.Make sure to have a new battery that matches the systems device.Before you begin ensure the device is turned off and disconnected from any external power source.Proceed to follow the guide steps to successfully replace a faulty battery.

Step 1

              Battery

Make sure the device is fully powered down and unplugged from external power.
Close the device and turn it over so it will be on its back.

Make sure the device is fully powered down and unplugged from external power.

Close the device and turn it over so it will be on its back.

1024

Step 2

In the red is the battery and the battery’s holding/locking latches.
Slide the latches in the direction the arrows face. This will unlock and release the battery.
Set the old battery aside or dispose of properly by following the manufacturers instructions written on the battery or check online of battery disposal services.

In the red is the battery and the battery’s holding/locking latches.

Slide the latches in the direction the arrows face. This will unlock and release the battery.

Set the old battery aside or dispose of properly by following the manufacturers instructions written on the battery or check online of battery disposal services.

Step 3

Check the battery port on your device and make sure it is clear of debris and pins are not bent or damaged.
Install the new battery into the port and press down gently.
Make sure it latches on to its locking clip.
Once installed and you have followed the battery manufacturer’s instructions, turn your device on to its upright position and boot your device.

Check the battery port on your device and make sure it is clear of debris and pins are not bent or damaged.

Install the new battery into the port and press down gently.

Make sure it latches on to its locking clip.

Once installed and you have followed the battery manufacturer’s instructions, turn your device on to its upright position and boot your device.

Device should be working as usual with the new battery.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Fernando Mendez

Member since: 08/25/2022

583 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Gateway, Team 1-2, Pee Fall 2022                        

                                                  Member of Gateway, Team 1-2, Pee Fall 2022 



                    GCC-PEE-F22S1G2                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

#

#

#

#

#

Team#

#

Introduction

Team