Hp Sprocket 2 In 1 Outer Casing Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          9 minutes

Sections

Outer Casing
7 steps

Flags

BackHP Sprocket 2-in-1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Outer Casing

Remove the back cover and any printer paper inside the device.

Remove the back cover and any printer paper inside the device.

1024

Step 2

Using the Jimmy, slowly pry open the outer edge of the remaining white plastic on the back.
Remove the plastic from the device once it lifts out freely.

Using the Jimmy, slowly pry open the outer edge of the remaining white plastic on the back.

Remove the plastic from the device once it lifts out freely.

Step 3

Remove two 2.5mm JIS #00 located on the small circuit board in view.
Use the Jimmy to remove the board after the screws have been removed.
Be careful not to crease or damage the ribbon cable.

Remove two 2.5mm JIS #00 located on the small circuit board in view.

Use the Jimmy to remove the board after the screws have been removed.

Be careful not to crease or damage the ribbon cable.

Step 4

Remove two 2.5mm JIS #00 screws from the translucent plastic bracket.
One will be located beneath the ribbon cable.
Remove the translucent plastic bracket by hand.

Remove two 2.5mm JIS #00 screws from the translucent plastic bracket.

One will be located beneath the ribbon cable.

Remove the translucent plastic bracket by hand.

Step 5

Remove four 2.5mm JIS #00 screws from the beige casing.

Remove four 2.5mm JIS #00 screws from the beige casing.

Step 6

Use the iFixit opening tool to slowly work between the white and beige casing around the device.
Flip the device over and seperate the white casing from the rest of the device.
Be careful not to break the plastic while removing the case.
Gently remove the white casing as there is a ribbon cable connecting the two pieces.

Use the iFixit opening tool to slowly work between the white and beige casing around the device.

Flip the device over and seperate the white casing from the rest of the device.

Be careful not to break the plastic while removing the case.

Gently remove the white casing as there is a ribbon cable connecting the two pieces.

Step 7

Carefully remove the ribbon cable that connects the flash to the outer casing.

Carefully remove the ribbon cable that connects the flash to the outer casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Kevin Steward

Member since: 02/05/2019

154 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       University of Michigan, Team S1-G4, Li Winter 2019                        

                                                  Member of University of Michigan, Team S1-G4, Li Winter 2019 



                    UMIC-LI-W19S1G4                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team