Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

3

  • Back Panel
  • 1 step
  • Battery
  • 3 steps
  • Audio Port
  • 4 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackHP Split x2 13-g210dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Carefully peel off the felt cover that is found beneath the display along the bottom of the device.
  • Use a spudger to gently scrape away the padding that hides the screws in each of the four locations.
  • Remove the four 4-mm Phillips #0 screws.
  • Run a spudger along the crease of the entire laptop and slowly pry off the back panel of the device, beginning with the bottom edge.
  • You will hear popping noises as the clips separate from each other.

Carefully peel off the felt cover that is found beneath the display along the bottom of the device.

Use a spudger to gently scrape away the padding that hides the screws in each of the four locations.

Remove the four 4-mm Phillips #0 screws.

Run a spudger along the crease of the entire laptop and slowly pry off the back panel of the device, beginning with the bottom edge.

You will hear popping noises as the clips separate from each other.

1024

Step 2

              Battery
  • Remove the three 6-mm Phillips #0 screws.
  • Remove the four 4-mm Phillips #0 screws.

Remove the three 6-mm Phillips #0 screws.

Step 3

  • Remove the white connector clip from the connector port using a sturdy tweezers.

Remove the white connector clip from the connector port using a sturdy tweezers.

Step 4

  • Lift the battery away from the device.

Lift the battery away from the device.

Step 5

              Audio Port
  • Remove the two 4-mm Phillips #0 screws.

Remove the two 4-mm Phillips #0 screws.

Step 6

  • Remove the two purple ribbons labeled “Audio” at the top of the audio port board using tweezers or a sturdy plastic opening tool.

Remove the two purple ribbons labeled “Audio” at the top of the audio port board using tweezers or a sturdy plastic opening tool.

Step 7

  • Remove the white clip at the top right corner of the audio port board using tweezers.

Remove the white clip at the top right corner of the audio port board using tweezers.

Step 8

  • Lift the Audio port away from the device.

Lift the Audio port away from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Isaac Van Baren

Member since: 02/26/2019

315 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Purdue University Northwest, Team S4-G1, Hingst Spring 2019                        

                                                  Member of Purdue University Northwest, Team S4-G1, Hingst Spring 2019 



                    PNW-HINGST-S19S4G1                     


                                            4 Members                     


                                            6 Guides authored