Hp Split 13 R010Dx Front And Back Panel Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Front and Back Panel
4 steps

Flags

BackHP Split X2 13-r000 Series
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front and Back Panel

Locate the four screws at the bottom of the device. (Note that the keyboard attachment is missing from this device.)
Use a Philips head #0 screwdriver to remove each of the screws (Size: 4mm)

Locate the four screws at the bottom of the device. (Note that the keyboard attachment is missing from this device.)

Use a Philips head #0 screwdriver to remove each of the screws (Size: 4mm)

1024

Step 2

Gently wedge the plastic opening tool in between where the display and back panel meet.
Slowly and gently apply force to the plastic opening tool in a downwards motion to loosen the front panel from the back panel.
Rotate the device so that the side is facing up and repeat the previous step for the sides.
Do NOT attempt to wedge the plastic opening tool on the bottom . Once the sides and top are loose you are ready to continue to the next step.

Gently wedge the plastic opening tool in between where the display and back panel meet.

Slowly and gently apply force to the plastic opening tool in a downwards motion to loosen the front panel from the back panel.

Rotate the device so that the side is facing up and repeat the previous step for the sides.

Do NOT attempt to wedge the plastic opening tool on the bottom . Once the sides and top are loose you are ready to continue to the next step.

Step 3

Gently and slowly pull the front and back panel away from each other (in opposite directions). ( Pulling them apart will not separate the two panels)
Only separate the panels by a few inches from each other so that there is room to separate the front and back panel in the next step. Proceed to the next step.

Gently and slowly pull the front and back panel away from each other (in opposite directions). ( Pulling them apart will not separate the two panels)

Only separate the panels by a few inches from each other so that there is room to separate the front and back panel in the next step. Proceed to the next step.

Step 4

Hold the back panel firmly and pull the front panel upwards to completely separate the front panel from the back panel.
The device is now ready to be repaired or replacements installed.

Hold the back panel firmly and pull the front panel upwards to completely separate the front panel from the back panel.

The device is now ready to be repaired or replacements installed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Kyle Jaeger

Member since: 09/25/2017

185 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S2-G1, Thompson Fall 2017                        

                                                  Member of University of North Texas, Team S2-G1, Thompson Fall 2017 



                    UNT-THOMPSON-F17S2G1                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team