Hp Spectre X360 13T 4000 Hard Drive Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Backplate
2 steps
Battery
1 step
Hard Drive
1 step

Flags

Featured Student Guide

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

BackHP Spectre x360 13t-4000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Backplate

Turn off and unplug the laptop.
Flip over the laptop so that the bottom backplate is exposed.

Turn off and unplug the laptop.

Flip over the laptop so that the bottom backplate is exposed.

1024

Step 2

With a hex T5 screwdriver remove the six 3mm screws holding the backplate.
Using the same screwdriver, remove the two 7mm screws.
With all the screws removed, use a plastic opening tool to lift off the backplate.

With a hex T5 screwdriver remove the six 3mm screws holding the backplate.

Using the same screwdriver, remove the two 7mm screws.

With all the screws removed, use a plastic opening tool to lift off the backplate.

Step 3

              Battery

With the backplate removed, remove the four 3 mm screws securing the battery with a Phillips #1 screwdriver.
With the screws removed, disconnect the 3 wires connected to the battery.
Tweezers may be needed to remove the wires.

With the backplate removed, remove the four 3 mm screws securing the battery with a Phillips #1 screwdriver.

With the screws removed, disconnect the 3 wires connected to the battery.

Tweezers may be needed to remove the wires.

Step 4

              Hard Drive

Using a Phillips #000 screwdriver, unscrew the one 2mm screw located to the left of the hard drive.
With the screw undone, use a plastic spudger, lifting the hard drive from the left side. Once the hard drive is at an angle, pull the hard drive out.

Using a Phillips #000 screwdriver, unscrew the one 2mm screw located to the left of the hard drive.

With the screw undone, use a plastic spudger, lifting the hard drive from the left side. Once the hard drive is at an angle, pull the hard drive out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Brandon Carvalho

Member since: 03/21/2019

566 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       UMass Dartmouth, Team S2-G4, Simcock Spring 2019                        

                                                  Member of UMass Dartmouth, Team S2-G4, Simcock Spring 2019 



                    UMASSD-SIMCOCK-S19S2G4                     


                                            3 Members                     


                                            6 Guides authored

Mackenzi Christenson - Aug 7, 2020

Will the 500 GB replacement kit work? It is recommended on this post but looks as though it is only compatible with Macs?

Crucial MX500 500 GB SSD

Featured Student Guide#

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Featured Student Guide

Introduction

What you need

Team