Difficulty
Moderate
Steps
3
Time Required
10 minutes
Sections
1
- Battery
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackHP Spectre x360 13-ac023dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip the laptop over so the model sticker faces the ceiling.
Flip the laptop over so the model sticker faces the ceiling.
1024
Step 2
- Use a Torx #5 screwdriver to remove the six 3.5 mm screws holding the back cover to the laptop.
Use a Torx #5 screwdriver to remove the six 3.5 mm screws holding the back cover to the laptop.
Step 3
- Use the Phillips #000 screwdriver to remove the four 3.5 mm screws holding the battery.
- After removing the screws, detach the battery wire from the mother board with the iFixit opening tool.
- Then, carefully lift the battery off with the iFixit opening tool.
Use the Phillips #000 screwdriver to remove the four 3.5 mm screws holding the battery.
After removing the screws, detach the battery wire from the mother board with the iFixit opening tool.
Then, carefully lift the battery off with the iFixit opening tool.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Dylan Beery
Member since: 10/21/2019
272 Reputation
1 Guide authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team S1-G6, Botvin Fall 2019
Member of UMass Dartmouth, Team S1-G6, Botvin Fall 2019
UMASSD-BOTVIN-F19S1G6
3 Members
6 Guides authored
Joseph Ficara - Nov 16, 2020
Reply
Also in my case there were no screws under the top or bottom feet, so I could have probably removed the cover without removing the feet.
