Difficulty
Moderate
Steps
7
Time Required
Suggest a time??
Sections
2
- Battery
- 4 steps
- Motherboard
- 3 steps
Flags
0
BackHP Slate 8 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove Back Panel
- Secure the suction cup to the center of the device’s screen.
- Begin to pull upwards with the suction cup. While pulling, start easing the plastic opening tool into the space between the screen and the device. This will gradually separate the screen from the plastic back panel.
Secure the suction cup to the center of the device’s screen.
Begin to pull upwards with the suction cup. While pulling, start easing the plastic opening tool into the space between the screen and the device. This will gradually separate the screen from the plastic back panel.
1024
Step 2
Remove yellow cables
- Use a spudger tool to release the black clips on the two connectors holding the flat, yellow cable in place.
- Use the tweezers to pull the flat, yellow cable out of its connectors.
- Use the tweezers to disconnect the battery connector from the circuit board.
- Using the spudger tool again, pry up and release the connectors at the ends of the flat, orange cable.
- Remove the flat, orange cable.
Use a spudger tool to release the black clips on the two connectors holding the flat, yellow cable in place.
Use the tweezers to pull the flat, yellow cable out of its connectors.
Use the tweezers to disconnect the battery connector from the circuit board.
Using the spudger tool again, pry up and release the connectors at the ends of the flat, orange cable.
Remove the flat, orange cable.
Step 3
Remove Screws Around Battery
- As shown, the battery is held in place by a total of 8 screws. Use the #00 Phillips screwdriver to remove all 8.
As shown, the battery is held in place by a total of 8 screws. Use the #00 Phillips screwdriver to remove all 8.
Step 4
Lift Battery out of Device
- Grasp the battery and remove it from the device.
- Do not attempt to open or tamper with the battery. This could result in injury.
Grasp the battery and remove it from the device.
Do not attempt to open or tamper with the battery. This could result in injury.
Step 5
Motherboard
- Disconnect the five connectors.
- With the zero insertion force connectors, be sure to flip up the tab to avoid damaging the connector.
- Use tweezers to disconnect the three antenna connectors
Disconnect the five connectors.
With the zero insertion force connectors, be sure to flip up the tab to avoid damaging the connector.
Use tweezers to disconnect the three antenna connectors
Step 6
- Remove the four PH#00 2.4mm screws that hold in the motherboard in place.
Remove the four PH#00 2.4mm screws that hold in the motherboard in place.
Step 7
- Use tweezers and a spudger to remove the motherboard.
- You may have to use a spudger to scrape off the adhesive holding the motherboard in place.
Use tweezers and a spudger to remove the motherboard.
You may have to use a spudger to scrape off the adhesive holding the motherboard in place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Andrew Hall
Member since: 05/23/2016
322 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
IUPUI, Team 1-4, Renguette SU 2016
Member of IUPUI, Team 1-4, Renguette SU 2016
IUPUI-RENGUETTE-SU16S1G4
4 Members
6 Guides authored
