Hp Slate 8 Pro Battery Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          5 - 10 minutes            

Sections

1

• Battery
• 4 steps

Flags

0

• BackHP Slate 8 Pro

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove Back Panel               

• Secure the suction cup to the center of the device’s screen.
• Begin to pull upwards with the suction cup. While pulling, start easing the plastic opening tool into the space between the screen and the device. This will gradually separate the screen from the plastic back panel.

Secure the suction cup to the center of the device’s screen.

Begin to pull upwards with the suction cup. While pulling, start easing the plastic opening tool into the space between the screen and the device. This will gradually separate the screen from the plastic back panel.

1024

Step 2

              Remove yellow cables               

• Use a spudger tool to release the black clips on the two connectors holding the flat, yellow cable in place.
• Use the tweezers to pull the flat, yellow cable out of its connectors.
• Use the tweezers to disconnect the battery connector from the circuit board.
• Using the spudger tool again, pry up and release the connectors at the ends of the flat, orange cable.
• Remove the flat, orange cable.

Use a spudger tool to release the black clips on the two connectors holding the flat, yellow cable in place.

Use the tweezers to pull the flat, yellow cable out of its connectors.

Use the tweezers to disconnect the battery connector from the circuit board.

Using the spudger tool again, pry up and release the connectors at the ends of the flat, orange cable.

Remove the flat, orange cable.

Step 3

              Remove Screws Around Battery               

• As shown, the battery is held in place by a total of 8 screws. Use the #00 Phillips screwdriver to remove all 8.

As shown, the battery is held in place by a total of 8 screws. Use the #00 Phillips screwdriver to remove all 8.

Step 4

              Lift Battery out of Device               

• Grasp the battery and remove it from the device.
• Do not attempt to open or tamper with the battery. This could result in injury.

Grasp the battery and remove it from the device.

Do not attempt to open or tamper with the battery. This could result in injury.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 9 other contributors 

                    Jose Revelo                     

Member since: 09/23/2014

305 Reputation

                                      3 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       USF Tampa, Team 9-4, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 9-4, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S9G4                     


                                            4 Members                     


                                            10 Guides authored