Difficulty
Difficult
Steps
7
Time Required
Suggest a time??
Sections
3
- Tablet Cover
- 3 steps
- Battery
- 2 steps
- Front Facing Webcamera
- 2 steps
Flags
2
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
Better Introduction
Improve this guide by completing or revising its introduction.
BackHP Slate 7 Plus 4200US
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Tablet Cover
- Turn off the tablet and disconnect the power and all external devices from the tablet.
- Position the tablet with the display panel down and the right side toward you.
- Carefully insert a plastic opening tool between the tablet cover and display panel assembly, separating the two components. The first insertion point should be between the power button and the volume buttons.
Turn off the tablet and disconnect the power and all external devices from the tablet.
Position the tablet with the display panel down and the right side toward you.
Carefully insert a plastic opening tool between the tablet cover and display panel assembly, separating the two components. The first insertion point should be between the power button and the volume buttons.
1024
Step 2
- Slide the tool around the perimeter of the tablet until the edge of the cover is completely separated from the display panel assembly.
Slide the tool around the perimeter of the tablet until the edge of the cover is completely separated from the display panel assembly.
Step 3
- Pry open the back cover to take it off.
Pry open the back cover to take it off.
Step 4
Battery
- Disconnect the battery cables from the system board by desoldering them. See iFixit guide on how to solder.
- The battery cables are soldered to the system in the following sequence, top to bottom: red, blue, green, yellow, black.
Disconnect the battery cables from the system board by desoldering them. See iFixit guide on how to solder.
The battery cables are soldered to the system in the following sequence, top to bottom: red, blue, green, yellow, black.
Step 5
- Insert a nylon spudger between the battery and the display panel assembly. Carefully pry the battery up and remove it from its place.
- The battery is attached to the display panel assembly with double-sided adhesive. Make sure to firmly pull the battery.
- The regular black nylon spudger should be used whenever possible, especially around batteries.
Insert a nylon spudger between the battery and the display panel assembly. Carefully pry the battery up and remove it from its place.
The battery is attached to the display panel assembly with double-sided adhesive. Make sure to firmly pull the battery.
The regular black nylon spudger should be used whenever possible, especially around batteries.
Step 6
Front Facing Webcamera
- Use tweezers to remove the black foam stickers from the front facing camera to expose the wiring.
Use tweezers to remove the black foam stickers from the front facing camera to expose the wiring.
Step 7
- Lift the camera out from system board and firmly pull the wire out from the connector.
Lift the camera out from system board and firmly pull the wire out from the connector.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Jessica Andrade
Member since: 10/04/2016
839 Reputation
7 Guides authored
Badges:
12
+9 more badges
Team
USF Tampa, Team 3-1, Sullivan Fall 2016
Member of USF Tampa, Team 3-1, Sullivan Fall 2016
USFT-SULLIVAN-F16S3G1
3 Members
14 Guides authored
