Hp Slate 7 Extreme 4400Us Charging Port And Audio Jack Circuit Board Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          10 minutes            

Sections

2

• Back Cover
• 1 step
• Charging port and Audio Jack Circuit Board
• 3 steps

Flags

0

• BackHP Slate 7 Extreme 4400US

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Cover               

• Use the plastic opening tool to separate the back cover from the tablet. Carefully use the tool to pry open the sides, going around the entire tablet to lift the sides up.
• Once all sides have been pried up, pull the cover off and place it to the side.

Use the plastic opening tool to separate the back cover from the tablet. Carefully use the tool to pry open the sides, going around the entire tablet to lift the sides up.

Once all sides have been pried up, pull the cover off and place it to the side.

1024

Step 2

              Charging port and Audio Jack Circuit Board               

• Use the PH #000 phillips head screw driver to remove one 5.0 mm screw.
• Move plastic housing and rear facing camera to expose silver bracket.

Use the PH #000 phillips head screw driver to remove one 5.0 mm screw.

Move plastic housing and rear facing camera to expose silver bracket.

Step 3

• Use the PH #000 phillips head screw driver to remove three 3.0mm screws. Remove the silver bracket.

Use the PH #000 phillips head screw driver to remove three 3.0mm screws. Remove the silver bracket.

Step 4

• Use the nylon spudger to flip up the black retaining flap of the zero insertion force (ZIF) connector holding the strip in place.
• Grab the green circuit board and pull directly up to separate the glued down power strip.
• Gently pull the circuit board out of its connector.

Use the nylon spudger to flip up the black retaining flap of the zero insertion force (ZIF) connector holding the strip in place.

Grab the green circuit board and pull directly up to separate the glued down power strip.

Gently pull the circuit board out of its connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Brandon Ko                     

Member since: 09/15/2016

698 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       USF Tampa, Team 11-4, Blackwell Fall 2016                        

                                                  Member of USF Tampa, Team 11-4, Blackwell Fall 2016 



                    USFT-BLACKWELL-F16S11G4                     


                                            4 Members                     


                                            16 Guides authored                     

cat jones - Aug 28, 2017

Reply

where can i get the part at?

Mountiansurfer Gaming - Nov 26, 2017

Reply

Where do you even get the part at??

Where do I even get the part at???

ypk77 - Feb 16, 2018

Reply

Can you let us know where to get the replacement part from?

Brian Burke - Nov 16, 2018

Reply

This is completely useless information without a source for the shoddy HP part!