Difficulty

Moderate

Steps

11

Time Required

                          20 - 45 minutes

Sections

3

  • Keyboard Assembly
  • 5 steps
  • Battery
  • 2 steps
  • Display Panel
  • 4 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHP ProBook x360 11 G5 EE

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard Assembly
  • Remove the 4.1 mm screws with a T5 Torx screwdriver.
  • Remove the 4.1 mm screws using a JIS #0 screwdriver.

Remove the 4.1 mm screws with a T5 Torx screwdriver.

Remove the 4.1 mm screws using a JIS #0 screwdriver.

1024

Step 2

  • Use an opening pick to pry the corners of the keyboard deck.

Use an opening pick to pry the corners of the keyboard deck.

Step 3

  • Use an opening pick or opening tool to pry around the sides of the keyboard assembly.

Use an opening pick or opening tool to pry around the sides of the keyboard assembly.

Step 4

  • Lift the keyboard assembly to expose two ribbon cables.
  • Lift the two plastic tabs that hold the cables in place on the motherboard
  • Slide the ribbon cables out of each connector.

Lift the keyboard assembly to expose two ribbon cables.

Lift the two plastic tabs that hold the cables in place on the motherboard

Slide the ribbon cables out of each connector.

Step 5

  • Remove the keyboard assembly from the rest of the computer.

Remove the keyboard assembly from the rest of the computer.

Step 6

              Battery
  • Remove the four 3 mm screws from the battery with the JIS #0 screwdriver.

Remove the four 3 mm screws from the battery with the JIS #0 screwdriver.

Step 7

  • Pry the battery up from the laptop using an opening pick.
  • Lift the battery out of its place.

Pry the battery up from the laptop using an opening pick.

Lift the battery out of its place.

Step 8

              Display Panel
  • Use the opening pick and metal spudger to pry open the display cover.

Use the opening pick and metal spudger to pry open the display cover.

Step 9

  • Remove the ribbon wire that is attached to the display cover to fully detach it.

Remove the ribbon wire that is attached to the display cover to fully detach it.

Step 10

  • Remove the four 2.3 mm screws holding the screen in place with the JIS #0 screwdriver.

Remove the four 2.3 mm screws holding the screen in place with the JIS #0 screwdriver.

Step 11

  • Lift the screen to disconnect the wire attaching it to the laptop.
  • Remove the display panel from the rest of the laptop.

Lift the screen to disconnect the wire attaching it to the laptop.

Remove the display panel from the rest of the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Michelle Pina

Member since: 10/26/2021

397 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Gateway, Team 1-4, Pee Fall 2021                        

                                                  Member of Gateway, Team 1-4, Pee Fall 2021 



                    GCC-PEE-F21S1G4                     


                                            6 Members                     


                                            5 Guides authored