Hp Probook 455 G1 Hard Drive Replacement Repair Guide

Difficulty

Easy

Steps

8

Time Required

                          15 - 20 minutes            

Sections

3

• Battery
• 3 steps
• Service Panel
• 2 steps
• Hard Drive
• 3 steps

Flags

0

• BackHP ProBook 455 G1

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Turn the computer upside down on a flat side, so that you are seeing the underside of the laptop.
• Before removing the battery, make sure that the computer is turned off and that the power cord is not plugged into the computer.

Turn the computer upside down on a flat side, so that you are seeing the underside of the laptop.

Before removing the battery, make sure that the computer is turned off and that the power cord is not plugged into the computer.

1024

Step 2

• Slide the two battery release latches towards the center of the laptop to release the battery.

Slide the two battery release latches towards the center of the laptop to release the battery.

Step 3

• Tilt the battery upward.
• Remove it from the laptop.

Tilt the battery upward.

Remove it from the laptop.

Step 4

              Service Panel               

• Slide the two release latches that were mentioned in the battery removal process to release the service panel.

Slide the two release latches that were mentioned in the battery removal process to release the service panel.

Step 5

• Slide the service panel toward you using your thumbs.
• Lift it to remove the panel and reveal inner components of the computer.

Slide the service panel toward you using your thumbs.

Lift it to remove the panel and reveal inner components of the computer.

Step 6

              Hard Drive               

• Using a Phillips #0 Screwdriver, remove the four Phillips 3 mm screws that secure the hard drive into the computer.

Using a Phillips #0 Screwdriver, remove the four Phillips 3 mm screws that secure the hard drive into the computer.

Step 7

• Pull the hard drive cover tab to the left in order to disconnect the hard drive from the computer.

Pull the hard drive cover tab to the left in order to disconnect the hard drive from the computer.

Step 8

• Finally, using the same tab, lift the hard drive out of the hard drive port.

Finally, using the same tab, lift the hard drive out of the hard drive port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      7 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Bailey Brammer                     

Member since: 03/18/2018

343 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Baylor, Team S5-G1, Williams Spring 2018                        

                                                  Member of Baylor, Team S5-G1, Williams Spring 2018 



                    BU-WILLIAMS-S18S5G1                     


                                            3 Members                     


                                            6 Guides authored