Difficulty
Easy
Steps
7
Time Required
5 minutes
Sections
3
- Battery
- 2 steps
- Backplate
- 2 steps
- Optical Drive
- 3 steps
Flags
0
BackHP ProBook 440 G1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Make sure the laptop is turned off before you start.
- Push and hold the release tab on the right and left toward the center.
Make sure the laptop is turned off before you start.
Push and hold the release tab on the right and left toward the center.
1024
Step 2
- Pull the battery out.
Pull the battery out.
Step 3
Backplate
- Push and hold the release tabs on the right and left toward the center again.
Push and hold the release tabs on the right and left toward the center again.
Step 4
- Slide the backplate off.
Slide the backplate off.
Step 5
Optical Drive
- Locate the optical drive, near the battery on the right side.
Locate the optical drive, near the battery on the right side.
Step 6
- Remove the Philips PM2.5x6.0 screw that attaches the optical drive to the computer.
Remove the Philips PM2.5x6.0 screw that attaches the optical drive to the computer.
Step 7
- Slowly remove the optical drive, by pulling it straight out of the slot.
Slowly remove the optical drive, by pulling it straight out of the slot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Ethan A Courtney
Member since: 10/24/2018
851 Reputation
7 Guides authored
Badges:
7
+4 more badges
Team
Purdue University Northwest, Team S1-G4, Hingst Fall 2018
Member of Purdue University Northwest, Team S1-G4, Hingst Fall 2018
PNW-HINGST-F18S1G4
1 Member
7 Guides authored
