Hp Prime Graphing Calculator G8X92A Button Panel Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          15 - 30 minutes            

Sections

2

• Battery
• 3 steps
• Button Panel
• 4 steps

Flags

0

• BackHP Prime Graphing Calculator G8X92AA

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Power down the device.
• Flip the device face side down so the back of the device is facing up.

Power down the device.

Flip the device face side down so the back of the device is facing up.

1024

Step 2

• Using a Phillips #00 screwdriver, remove the two 4.5 mm screws securing the battery cover located at the bottom center of the device.
• Remove the cover.

Using a Phillips #00 screwdriver, remove the two 4.5 mm screws securing the battery cover located at the bottom center of the device.

Remove the cover.

Step 3

• Remove the battery.

Remove the battery.

Step 4

              Button Panel               

• Using a Phillips #00 screwdriver, remove the four 4.5 mm screws securing the back panel to the device.

Using a Phillips #00 screwdriver, remove the four 4.5 mm screws securing the back panel to the device.

Step 5

• Using a spudger, gently pry apart the front and back panels.

Using a spudger, gently pry apart the front and back panels.

Step 6

• Using a Phillips #00 screwdriver, remove the eleven 3 mm screws securing the battery board/button panel located at the bottom half of the device.
• Using a plastic opening tool, gently pry the retaining clip securing the ribbon cable to the top-left side of the board.
• Using plastic tweezers, gently unplug the ribbon cable from the board.

Using a Phillips #00 screwdriver, remove the eleven 3 mm screws securing the battery board/button panel located at the bottom half of the device.

Using a plastic opening tool, gently pry the retaining clip securing the ribbon cable to the top-left side of the board.

Using plastic tweezers, gently unplug the ribbon cable from the board.

Step 7

• Using a plastic opening tool, gently pry upward on the battery board/button panel from the bottom to remove.

Using a plastic opening tool, gently pry upward on the battery board/button panel from the bottom to remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Eric A Bidema                     

Member since: 09/16/2020

358 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       The Citadel Military College of South Carolina, Team S2-G15, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S2-G15, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S2G15                     


                                            3 Members                     


                                            6 Guides authored