Hp Photosmart M547 Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Screen
9 steps

Flags

BackHP Camera
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Disconnect from all power sources. (Remove batteries, chargers, etc.)

Disconnect from all power sources. (Remove batteries, chargers, etc.)

1024

Step 2

Remove the five 5mm screws from the bottom of the camera with a PH00 screwdriver.

Remove the five 5mm screws from the bottom of the camera with a PH00 screwdriver.

Step 3

Pop the silver siding off of the camera. Proceed carefully as to not break the plastic.

Pop the silver siding off of the camera. Proceed carefully as to not break the plastic.

Step 4

Make sure that the siding is fully removed and the battery dock is open. Carefully pry the top off of the camera.

Make sure that the siding is fully removed and the battery dock is open. Carefully pry the top off of the camera.

Step 5

Approach from the front of the camera, make sure that the black/red wires as not covering the screw.
Carefully remove the black 5mm screw from the camera with a PH00 screwdriver.

Approach from the front of the camera, make sure that the black/red wires as not covering the screw.

Carefully remove the black 5mm screw from the camera with a PH00 screwdriver.

Step 6

Flip the camera over and pop off the plastic siding.

Flip the camera over and pop off the plastic siding.

Step 7

Look for the silver 5mm screw connecting the screen to the circuit board. Then carefully remove it using a PH00 screwdriver.
On the opposite corner of the screen there is a similar screw. Carefully remove that one as well.
You may need to peel back thin, black plastic to get to the screw. The plastic is purely there for dust protection.

Look for the silver 5mm screw connecting the screen to the circuit board. Then carefully remove it using a PH00 screwdriver.

On the opposite corner of the screen there is a similar screw. Carefully remove that one as well.

You may need to peel back thin, black plastic to get to the screw. The plastic is purely there for dust protection.

Step 8

When you lift the screen off of the rest of the camera, you will see a small piece of ribbon wire connecting the screen and circuit board.
To remove this connection, you must lift the black bar at the base of the ribbon wire (on the circuit board), then slide the ribbon wire out.

When you lift the screen off of the rest of the camera, you will see a small piece of ribbon wire connecting the screen and circuit board.

To remove this connection, you must lift the black bar at the base of the ribbon wire (on the circuit board), then slide the ribbon wire out.

Step 9

Congratulations! You have removed the screen, you can now replace it and reassemble your camera.

Congratulations! You have removed the screen, you can now replace it and reassemble your camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Jason Curran

Member since: 02/08/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Central Coast New Tech High, Team 5-8, Rushing Spring 2017                        

                                                  Member of Central Coast New Tech High, Team 5-8, Rushing Spring 2017 



                    CCNTH-RUSHING-S17S5G8                     


                                            2 Members                     


                                            2 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team