Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

1

  • Fan
  • 6 steps

Flags

0

  • BackHP Pavilion x360 m3-u103dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Fan
  • Power off device.
  • Flip laptop over.

Power off device.

Flip laptop over.

1024

Step 2

  • Remove the rubber foot with a Metal spudger
  • Remove 5 Phillip 2.4 x 5.7mm screws using a PH0 Phillips head screwdriver.
  • Remove 5 Phillips 2.8 x 5.0mm screws using a PH0 Phillips head screwdriver.

Remove the rubber foot with a Metal spudger

Remove 5 Phillip 2.4 x 5.7mm screws using a PH0 Phillips head screwdriver.

Remove 5 Phillips 2.8 x 5.0mm screws using a PH0 Phillips head screwdriver.

Step 3

  • Open computer and pry open keyboard panel using the Metal Spudger. Apply little pressure then increase until keyboard pops away from motherboard.
  • Gently lift keyboard on the mouse pad side. Remove three connected ribbon wires connecting keyboard to frame by gently disconnecting them from the motherboard.

Open computer and pry open keyboard panel using the Metal Spudger. Apply little pressure then increase until keyboard pops away from motherboard.

Gently lift keyboard on the mouse pad side. Remove three connected ribbon wires connecting keyboard to frame by gently disconnecting them from the motherboard.

Step 4

  • Remove eleven 2.0 x 4.6mm screws using the Phillips 00 Screwdriver

Remove eleven 2.0 x 4.6mm screws using the Phillips 00 Screwdriver

Step 5

  • Remove the motherboard gently from the base of the laptop.
  • Disconnect the fastened cables from the motherboard by carefully pushing the cable’s plastic edges using the metal Spudger.

Remove the motherboard gently from the base of the laptop.

Disconnect the fastened cables from the motherboard by carefully pushing the cable’s plastic edges using the metal Spudger.

Step 6

  • Using the Phillips 00 Screw Driver. remove 4 screws from the heat sink.
  • Remove any adhesive tape. Detach the fan/heat sink.

Using the Phillips 00 Screw Driver. remove 4 screws from the heat sink.

Remove any adhesive tape. Detach the fan/heat sink.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Meaghan Hyatt

Member since: 01/17/2019

355 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Eastern Washington University, Team S2-G6, Munoz Winter 2019                        

                                                  Member of Eastern Washington University, Team S2-G6, Munoz Winter 2019 



                    EWU-MUNOZ-W19S2G6                     


                                            4 Members                     


                                            3 Guides authored