Hp Pavilion X360 15T Br000 Fan And Heatsink Assembly Replacement Repair Guide

Difficulty

Difficult

Steps

6

Time Required

                          30 minutes            

Sections

2

• Keyboard Panel
• 2 steps
• Fan and Heatsink Assembly
• 4 steps

Flags

0

• BackHP Pavilion x360 15t-br000

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

One side of the fan is at the bottom of the mainboard. So the mainboard should be replaced first. The laptop may be overheated if the fan is broken.

Remember to shut down the laptop when doing the replacement.

What you need

Step 1

              Keyboard Panel               

• Remove the covers to access the screws attached to the back cover of the device.
• Remove six 3mm screws using the Phillips #0 screwdriver.

Remove the covers to access the screws attached to the back cover of the device.

Remove six 3mm screws using the Phillips #0 screwdriver.

1024

Step 2

• Use a metal spudger to loosen the four corners of the keyboard panel. The corner is circled red as shown in the first image.
• Disconnect the keyboard panel cables under the upper case.
• Remove the keyboard panel from the device.

Use a metal spudger to loosen the four corners of the keyboard panel. The corner is circled red as shown in the first image.

Disconnect the keyboard panel cables under the upper case.

Remove the keyboard panel from the device.

Step 3

              Fan and Heatsink Assembly               

• Remove all three 3.5 mm screws using the Phillips #0 screwdriver.
• Disconnect the cables above the fan.
• Disconnect the wire next to the fan.

Remove all three 3.5 mm screws using the Phillips #0 screwdriver.

Disconnect the cables above the fan.

Disconnect the wire next to the fan.

Step 4

• Remove nine 4mm screws using the Phillips #0 screwdriver.

Remove nine 4mm screws using the Phillips #0 screwdriver.

Step 5

• Flip over the motherboard.

Flip over the motherboard.

Step 6

• Remove four 3.5mm screws using the Phillips #0 screwdriver.
• Remove the fan and heatsink assembly from the device.

Remove four 3.5mm screws using the Phillips #0 screwdriver.

Remove the fan and heatsink assembly from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    xi yang                     

Member since: 10/01/2019

403 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Duke University Pratt School of Engineering, Team S5-G3, Matos-Garner Fall 2019                        

                                                  Member of Duke University Pratt School of Engineering, Team S5-G3, Matos-Garner Fall 2019 



                    DUKEPSE-MATOS-GARNER-F19S5G3                     


                                            5 Members                     


                                            4 Guides authored