Hp Pavilion X360 14M Ba011Dx Speakers Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 15 minutes

Sections

Speakers
6 steps

Flags

BackHP Pavilion x360 14m-ba011dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

With this guide, users will be able to remove and replace the speakers on the HP Pavilion x360 14m-ba011dx laptop. The model number for this device is 1KT47UA. Removal of the speakers will be needed if they are not producing sound or the sound is inconsistent.

What you need

Step 1

              Speakers

Remove the top left and right rubber pads closest to the hinge of screen using a plastic spudger to locate the screws underneath.
Remove the following 6 screws from the bottom of the device using a Phillips #00 Screwdriver:
Remove two 7.5 mm screws.
Remove three 5 mm screws.
Remove one 6.5 mm screw.

Remove the top left and right rubber pads closest to the hinge of screen using a plastic spudger to locate the screws underneath.

Remove the following 6 screws from the bottom of the device using a Phillips #00 Screwdriver:

Remove two 7.5 mm screws.

Remove three 5 mm screws.

Remove one 6.5 mm screw.

1024

Step 2

Push into the two screw holes that were under the rubber pads with the screwdriver to pop the keyboard out just a little.
Do this with the screen open so that you do not damage the screen.
Do not remove keyboard all the way.

Push into the two screw holes that were under the rubber pads with the screwdriver to pop the keyboard out just a little.

Do this with the screen open so that you do not damage the screen.

Do not remove keyboard all the way.

Step 3

Separate the keyboard from the rest of the device using a metal spudger around edges.
Pull up gently just until you can see the cables attaching the keyboard to the motherboard.
Flip the small white flaps holding the cables to the motherboard open to unplug the cords.

Separate the keyboard from the rest of the device using a metal spudger around edges.

Pull up gently just until you can see the cables attaching the keyboard to the motherboard.

Flip the small white flaps holding the cables to the motherboard open to unplug the cords.

Step 4

Disconnect the wires labeled 1 and 2 out.

Disconnect the wires labeled 1 and 2 out.

Step 5

Disconnect two ZIF connectors from the motherboard.
Remove three 4mm screws using a Phillips #00 Screwdriver.

Disconnect two ZIF connectors from the motherboard.

Remove three 4mm screws using a Phillips #00 Screwdriver.

Step 6

Gently remove the speakers from the device.

Gently remove the speakers from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Katie Pruis

Member since: 01/16/2020

778 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Embry-Riddle Aeronautical University, Team S7-G5, Rauch Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S7-G5, Rauch Spring 2020 



                    ERAU-RAUCH-S20S7G5                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team