Difficulty

Moderate

Steps

6

Time Required

                          25 minutes

Sections

2

  • Battery
  • 2 steps
  • Keyboard
  • 4 steps

Flags

0

  • BackHP Pavilion g7-1368dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn the device over so that the lower case is facing up.
  • Slide the battery release latch. The battery will pop up.

Turn the device over so that the lower case is facing up.

Slide the battery release latch. The battery will pop up.

1024

Step 2

  • Lift and remove the battery from its compartment.

Lift and remove the battery from its compartment.

Step 3

              Keyboard
  • Loosen the two Phillips #1 screws that connect the service panel to the device.
  • These are captive screws and cannot be fully removed. They will remain attached to the service panel.
  • Slide the service panel down and pull it up to remove.

Loosen the two Phillips #1 screws that connect the service panel to the device.

These are captive screws and cannot be fully removed. They will remain attached to the service panel.

Slide the service panel down and pull it up to remove.

Step 4

  • Remove the one 7 mm Phillips #1 screw securing the keyboard to the device.

Remove the one 7 mm Phillips #1 screw securing the keyboard to the device.

Step 5

  • Flip over the device and open the screen.

Flip over the device and open the screen.

Step 6

  • Flip the keyboard over and locate the black ribbon cable that attaches the keyboard to the device.
  • Using a plastic opening tool, flip up the white tab on the zero insertion force connector.
  • Disconnect the ribbon cable by sliding it out of the ZIF connector.
  • Remove the keyboard.

Flip the keyboard over and locate the black ribbon cable that attaches the keyboard to the device.

Using a plastic opening tool, flip up the white tab on the zero insertion force connector.

Disconnect the ribbon cable by sliding it out of the ZIF connector.

Remove the keyboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Kianna Young

Member since: 01/16/2019

109 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       University of Alabama, Team S2-G2, Bedsole Spring 2019                        

                                                  Member of University of Alabama, Team S2-G2, Bedsole Spring 2019 



                    UA-BEDSOLE-S19S2G2                     


                                            3 Members                     


                                            3 Guides authored