Difficulty

Easy

Steps

4

Time Required

                          6 minutes

Sections

3

  • Battery
  • 2 steps
  • Service Door
  • 1 step
  • RTC Battery
  • 1 step

Flags

0

  • BackHP Pavilion g7-1365dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • To prevent injury, make sure the laptop is powered off before removing the battery.
  • Flip the laptop so that it is upside down and opens away from you. This exposes the battery, it will be centered at the bottom of the laptop .
  • Push the switch above the battery towards the center of the laptop .

To prevent injury, make sure the laptop is powered off before removing the battery.

Flip the laptop so that it is upside down and opens away from you. This exposes the battery, it will be centered at the bottom of the laptop .

Push the switch above the battery towards the center of the laptop .

1024

Step 2

  • While pushing the switch, lift the battery by the side closest to the switch up and away from the laptop.

While pushing the switch, lift the battery by the side closest to the switch up and away from the laptop.

Step 3

              Service Door
  • Using a Phillips size 0 screwdriver, unscrew the 2 Phillips screws.
  • Use the opening tool around the edges of the service door to loosen it and remove it.

Using a Phillips size 0 screwdriver, unscrew the 2 Phillips screws.

Use the opening tool around the edges of the service door to loosen it and remove it.

Step 4

              RTC Battery
  • Disconnect the RTC battery power cable from the system board.
  • Remove the RTC battery from the system board. (The RTC battery is attached to the system board with double-sided tape.)
  • Slide the RTC battery out from under the surface of the base enclosure.

Disconnect the RTC battery power cable from the system board.

Remove the RTC battery from the system board. (The RTC battery is attached to the system board with double-sided tape.)

Slide the RTC battery out from under the surface of the base enclosure.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Derrick Manu

Member since: 03/18/2019

245 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team S1-G1, Simcock Spring 2019                        

                                                  Member of UMass Dartmouth, Team S1-G1, Simcock Spring 2019 



                    UMASSD-SIMCOCK-S19S1G1                     


                                            4 Members                     


                                            8 Guides authored