Difficulty

Moderate

Steps

6

Time Required

                          30 - 35 minutes            

Sections

1

  • LCD Screen
  • 6 steps

Flags

0

  • BackHP Pavilion dv6000

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              LCD Screen               
  • Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.
  • Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.

Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.

Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.

1024

Step 2

  • Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.

Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.

Step 3

  • Remove the two screws (5.8mm) on either side of the LCD near the hinge. Remove the screws on the outermost side first.

Remove the two screws (5.8mm) on either side of the LCD near the hinge. Remove the screws on the outermost side first.

Step 4

  • Take out the two 3.58mm screws on the LCD at the top (one on each edge).

Take out the two 3.58mm screws on the LCD at the top (one on each edge).

Step 5

  • Hold on to the LCD screen to prevent it from falling over and remove the two 3.58mm screws on the sides at the bottom.

Hold on to the LCD screen to prevent it from falling over and remove the two 3.58mm screws on the sides at the bottom.

Step 6

  • Let the screen gently rest on the keyboard.
  • Remove the tape from the ribbon.
  • Stop here and check the cable

Let the screen gently rest on the keyboard.

Remove the tape from the ribbon.

Stop here and check the cable

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      15 other people completed this guide.                                             

Author

                                      with 8 other contributors 

                    Ben Hirsch                     

Member since: 10/05/2010

3,826 Reputation

                                      10 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges                           

Team

                       Cal Poly, Team 21-33, Regan Fall 2010                        

                                                  Member of Cal Poly, Team 21-33, Regan Fall 2010 



                    CPSU-REGAN-F10S21G33                     


                                            4 Members                     


                                            12 Guides authored                     

firelionkofi - May 31, 2015

Reply

after replacing my cracked screen the back light does not show again