Hp Pavilion Dv6000 Camera Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          20 - 25 minutes            

Sections

1

• Camera
• 6 steps

Flags

0

• BackHP Pavilion dv6000

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Camera               

• Remove rubber screw covers from the LCD screen. They cover the screws. The stops on the top of the screen pop off, but the lower covers require a screwdriver to remove.
• If you need to use the screwdriver to remove the rubber screw covers, gently push the screwdriver down the edge of the stopper and then use the screwdriver as a lever to pry the cover from the hole.
• Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.

Remove rubber screw covers from the LCD screen. They cover the screws. The stops on the top of the screen pop off, but the lower covers require a screwdriver to remove.

If you need to use the screwdriver to remove the rubber screw covers, gently push the screwdriver down the edge of the stopper and then use the screwdriver as a lever to pry the cover from the hole.

Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.

1024

Step 2

• Press the tabs in on the sides of the screen and pop the plastic covering off.
• The edges of the LCD screen are very sharp. Take care to not cut your fingers!

Press the tabs in on the sides of the screen and pop the plastic covering off.

The edges of the LCD screen are very sharp. Take care to not cut your fingers!

Step 3

• Lift the screen out of the casing at the top near the camera.
• Take care to not snap the plastic casing! It is brittle and still attached to the bottom of the screen.

Lift the screen out of the casing at the top near the camera.

Take care to not snap the plastic casing! It is brittle and still attached to the bottom of the screen.

Step 4

• Gently remove the main cable from the camera.

Gently remove the main cable from the camera.

Step 5

• There are three clasps holding the camera down. Gingerly lift the camera board up, being careful not to snap the board, clasps, or vertical plastic pins (inside the gold-colored rings).
• The metal tabs to the left and right of the camera (for the LCD) are sharp, watch your fingers!

There are three clasps holding the camera down. Gingerly lift the camera board up, being careful not to snap the board, clasps, or vertical plastic pins (inside the gold-colored rings).

The metal tabs to the left and right of the camera (for the LCD) are sharp, watch your fingers!

Step 6

• Remove the camera unit from the laptop and you are done!

Remove the camera unit from the laptop and you are done!

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 6 other contributors 

                    Ben Hirsch                     

Member since: 10/05/2010

3,826 Reputation

                                      10 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges                           

Team

                       Cal Poly, Team 21-33, Regan Fall 2010                        

                                                  Member of Cal Poly, Team 21-33, Regan Fall 2010 



                    CPSU-REGAN-F10S21G33                     


                                            4 Members                     


                                            12 Guides authored