Hp Pavilion Dv6 6117Dx Ram Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          2 - 5 minutes            

Sections

1

• RAM
• 5 steps

Flags

0

• BackHP Pavilion dv6-6117dx

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              RAM               

• Begin removing the bottom cover by sliding the battery removal slider to the right to pop off the top of the cover.

Begin removing the bottom cover by sliding the battery removal slider to the right to pop off the top of the cover.

1024

Step 2

• Slide a black spudger under the top of the cover to loosen the clips underneath.

Slide a black spudger under the top of the cover to loosen the clips underneath.

Step 3

• Slide the spudger down the left side of the cover to loosen the clips.
• After the left side is loose, the rest of the cover should pop off, and you can remove it with your hands.
• When reassembling, insert the bottom of the cover first, and then firmly press along the edges from bottom to top to secure it in place.

Slide the spudger down the left side of the cover to loosen the clips.

After the left side is loose, the rest of the cover should pop off, and you can remove it with your hands.

When reassembling, insert the bottom of the cover first, and then firmly press along the edges from bottom to top to secure it in place.

Step 4

• Push the tabs on both sides away from each other to free the RAM, which will raise to a 45º angle.

Push the tabs on both sides away from each other to free the RAM, which will raise to a 45º angle.

Step 5

• Always handle RAM by the edges to avoid damaging the part.
• Remove the RAM by grabbing it by the sides and pulling out at a 45º angle.
• When inserting the new stick of RAM, you should insert it at this same angle.

Always handle RAM by the edges to avoid damaging the part.

Remove the RAM by grabbing it by the sides and pulling out at a 45º angle.

When inserting the new stick of RAM, you should insert it at this same angle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Joshua Holme                     

Member since: 03/19/2018

681 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       UMass Dartmouth, Team S6-G3, Bernier Spring 2018                        

                                                  Member of UMass Dartmouth, Team S6-G3, Bernier Spring 2018 



                    UMASSD-BERNIER-S18S6G3                     


                                            3 Members                     


                                            4 Guides authored